Mr. Bill's Pipe & Tobacco Company

• Hands Free Operation w/ Glass Joints
• Lighted Digital Temperature Display
• 5 Year Manufacturers Warranty
• 6"l x 3 5/8"w x 5"h 

Insert fuse (2amp) into back of vaporizer unit, needed to function.

Turn on vaporizer unit and increase the temperature to its highest setting.

Let the unit run at this level for 15 minutes. As this will burn off the manufactures packing oils on the ceramic heating element. Make sure you do this in a well ventilated area.

Getting Ready to Use the Easy Vape Vaporizer

Turn on the vaporizer unit by pushing in the knob on the front of the unit and increase the temperature to 320 - 350 degrees by turning the knob clockwise and adjusting the temperature.

(Check the heating element for a dim red glow. If the heating element is bright orange turn off for 10 seconds and reset)

Now let the vaporizer unit warm up for two minutes. When unit is ready, place the vapor whip filled with your smoking material over the heating element.

Grind up material and suck up into the tip of the glass hand piece. Recommended load is 1/3 or less of the bowl volume (from screen to tip) lightly packed down.

Vaporizing with the Easy Vape Vaporizer

Exhale all your breath and place your mouth to the mouthpiece of the vapor whip.

Touch the Pyrex tip to the glass slipper covering the heating element, hold it there and take a continuous steady breaths releasing the Pyrex tip from the element right before you are done in order to clear the tube.

If you draw too slowly and the heating element is too hot, you may catch the material on fire. In this case blowout immediately and repack with fresh material.

Be sure to experiment with different settings and varying draw velocities.